Chri5B
23-10-2006, 20:29
I've been replacing my Alpine HU with the factory Aura head-unit tonight.
As is well apart from the unit resets when you turn the ignition off.
When I removed the Alpine loom, on the connector which plugs into the bottom section of the Alana I found that one of the pins had been removed from the block and taped up. I guess it wasn't needed to feed the Alpine.
I'm not sure which pin in the block it should go back into. I had a choice of three:
2: Tel-mute
3: K-Leitung
5: Switched Plus
I have tried the pin in Switched Plus but it didn't work.
Have I missed something else? Does the pin need to go to somewhere other than "Switched Plus"?
I have unused red wire that was feeding the Alpine but that has a different connector on it, so won't fit back into the block. I wonder if the connector was changed to fit the Alpine? There was also a fused yellow wire for the Alpine.
Help!
As is well apart from the unit resets when you turn the ignition off.
When I removed the Alpine loom, on the connector which plugs into the bottom section of the Alana I found that one of the pins had been removed from the block and taped up. I guess it wasn't needed to feed the Alpine.
I'm not sure which pin in the block it should go back into. I had a choice of three:
2: Tel-mute
3: K-Leitung
5: Switched Plus
I have tried the pin in Switched Plus but it didn't work.
Have I missed something else? Does the pin need to go to somewhere other than "Switched Plus"?
I have unused red wire that was feeding the Alpine but that has a different connector on it, so won't fit back into the block. I wonder if the connector was changed to fit the Alpine? There was also a fused yellow wire for the Alpine.
Help!