ibiza_95
20-12-2006, 17:58
Its easiest if you can see how it is assembled, then you can get a basic idea of what you are trying to undo, and remove, so here is the basic assembly of the parts after theyve been taken off.
http://img104.imageshack.us/img104/403/linedupyp0.jpg
1. Firstly you need to undo the bolt under the 'S' badge... if you can undo this then its easy away, and the rest is a piece of piss. If you managed to undo this bolt then move to step 4...... And well done
http://img162.imageshack.us/img162/5908/1stbolthg7.jpg
2. If you cant undo the bolt then dont worry...
take the rear trim panel inside the boot out, and locate the back of the screw mentioned in step 1. It will be a regular screw into a plastic expanding bolt. The easiest way i found to get the screw out was to melt the plastic 'bolt' with a lighter until i could just force the screw through the middle of it . You may need to remove some material on the 'bolt' but either way heat it up until its fully burnt, (may take a minute) and then push the screw through.
3. Pull the trim off the back of the car, far enough that the screw is out of the hole and not touching any body work.
4. Then slide the left hand trim panel on boot left, so that in unhooks all the lugs which hold it in place.
These are what you are aiming to unhook
http://img186.imageshack.us/img186/1029/clipsmt6.jpg
5. Once youve done that, do the same on the other side and then the whole thing will be removed :D
Easy peasy (when you know how anyway)
USE AT YOU OWN RISK
(suppose id better put that eh)
http://img104.imageshack.us/img104/403/linedupyp0.jpg
1. Firstly you need to undo the bolt under the 'S' badge... if you can undo this then its easy away, and the rest is a piece of piss. If you managed to undo this bolt then move to step 4...... And well done
http://img162.imageshack.us/img162/5908/1stbolthg7.jpg
2. If you cant undo the bolt then dont worry...
take the rear trim panel inside the boot out, and locate the back of the screw mentioned in step 1. It will be a regular screw into a plastic expanding bolt. The easiest way i found to get the screw out was to melt the plastic 'bolt' with a lighter until i could just force the screw through the middle of it . You may need to remove some material on the 'bolt' but either way heat it up until its fully burnt, (may take a minute) and then push the screw through.
3. Pull the trim off the back of the car, far enough that the screw is out of the hole and not touching any body work.
4. Then slide the left hand trim panel on boot left, so that in unhooks all the lugs which hold it in place.
These are what you are aiming to unhook
http://img186.imageshack.us/img186/1029/clipsmt6.jpg
5. Once youve done that, do the same on the other side and then the whole thing will be removed :D
Easy peasy (when you know how anyway)
USE AT YOU OWN RISK
(suppose id better put that eh)