Custom Exhauxt Fabrication

[Hayz]

Hello,

Don't know how easy this would be to do but was just after whether you would be able to do it and how much it would cost roughly.

I want the back box taken off of my car and an additional piece of pipe attached the to centre pipe, which will bend round so that I have a side exit exhaust??

Does an MOT require 2 silencers??

Hope you can help.

Thanks.

[JKM]

Hello Hayz,

Sorry we havent got back to you on this yet, Ive only just seen the post!
Things have been very busy recently!

We will be back in contact with you on this hopefully at some point tomorrow.

Thanks

Keith

[Hayz]

Thats fine.. no massive rush :)

[RobM]

Ooooh.... can you let the rest of us know what the outcome of this is? If it's something JKM can offer that would be very good to know :)

[JKM]

Hi Hayz,

I have spoken to Jim on this and this isn't something we would be able to offer.

I would suggest that you prehaps try a custom exhaust workshop, there are a few around now who are kitted out with the right gear and who will have the required materials as stock and should be able to do this mod for you.

Sorry we can't help this time round :(

Kind regards
Kate @ JKM

[Hayz]

Ok no worries.

Thanks anyway.

[caney]

Ok no worries.

Thanks anyway.i use rsfabrications based in banbury,bit of a trek for you though:) http://rsfabrications.com/

[chrisbond69]

I found a write up on them sound bloody good

[__B3NNY__]

Good post :D i think im going to pop up and see these tommrow about getting my milltek system adjusted so it doesnt knock on the rear beam!

David.