Centre Caps - help!

[BeezerDiesel]

Could do with some centre caps to fit my alloys to ease cleaning etc.
They are currently an open bolt design and the cap diameter would need to be 14cm (5.5inch) and flat in profile (and circular, unlike some of the newer factory designs). Any manufacturer of wheel/car would do as logo's can be changed easily enough - I just need to know the right measurements so I can contact dealers/importers.
If anyone has a measuring implement to hand and could pop outside for a couple of seconds that would be much apreciated, thanks.:sonar:
(Got a feeling Beezer Cupra 8v 15 caps might be of similar dimensions if anyone has got one of these parked outside, ta) :cheers:

[m0rk]

14.5cm edge to edge bud

Mark

[BeezerDiesel]

Thanks Mark - you didn't hang about! Take it you meant the 8v Cupra 15"s

[m0rk]

yeah - sorry
i think the internal is about 6cm but it's cold & wet outside :D

[BeezerDiesel]

Thanks once agian Mark - these could well fit - now to find a dealer that has one in stock to trial fit....
:cheers:

[m0rk]

thing is - they're grey & may not match

Part number is 6K0 601 149D sold seperatly

Mark

[BeezerDiesel]

Silly question time- how dark a grey?
I know it's getting dark and that....

[BeezerDiesel]

Just been outside and re-measured and the cap need to be 14cm dead so I think they might not quite fit flush.
Anyone else got caps?????