how did you take your seats out how many bolts were ther and was it easy to do
Icecavern
22-07-2003, 08:34
Very easy...
ignition off, key out, disconnect the negative terminal of the battery to be sure if you're worried ( but I didn't )
Then there's 2 bolts at the front of the seat in the middle. Undo these and then tilt the seat back. Unclip the airbag wires, then slide the seat back until it comes out of the runners...
Job done...
When refitting make sure that the airbag plug is securely fitted again before bolting the seat in.
NOTE: While the seats are out DO NOT turn the ignition on etc or the airbag system will sense the fact that they aren't there and you'll need to get a dealer to reset it.
Pete