flushed interior - ibiza

[hoggers]

Bit of sad one im affraid but couple of things niggling me. first does any body elses glove box not sit flush, ordered a new clip to hold screw in place but it doesn't make a difference, still leaving a slight over hang.

Also i noticed on my dash just above the volume control, where the main centre piece meets with the bulk of the dash it does not sit properly but jauts out, only minor but still winds me up. looked at a ibiza on the fore court today and it to had the same problem...weird looks as though its been taken out at some stage and not put back properly.

well moan over im off into town

[Deejay]

Originally posted by hoggers

Also i noticed on my dash just above the volume control, where the main centre piece meets with the bulk of the dash it does not sit properly but jauts out, only minor but still winds me up. looked at a ibiza on the fore court today and it to had the same problem...weird looks as though its been taken out at some stage and not put back properly.

well moan over im off into town

If mk3 ibiza:
the dash unit wants installing again matey-undo the two cross head screws underneath and the facia section comes away but be careful and take your time so as not to damage the cable ribbon to the facia unit from the silver controls box.Inside on the back of the facia you will see 6 compression clips that hold the control area in place to the dash.
Basically:make sure all these clips are doing there job properly,you may want to open up the clips more with a screwdriver to make them bite better into the dash housing.

hope this helps and iv'e understood what you were on about properly-ignore me if not,ive had a few stella's:cheers:

[hoggers]

spot on i ll give it ago

[Deejay]

Originally posted by hoggers
spot on i ll give it ago

few,mine and mikes did this until i sorted them both out,common fault i'm afraid but as above very simple to correct when you know how!

DJ