PDA

View Full Version : Leon Mk1 Cable Routing for amp


OFI
14-08-2009, 23:52
I'm sure this must have been asked before but I can't find anything.

I have a Leon Cupra and looking under the bonnet for somewhere to route the power cable earlier was pretty off putting. Which is the best access through the bulhead and where should you go from there? Behind dash, down side, along sills and under seat?

Is it easy to run cables down the centre?

Not installed anything in a car before where you can't quickly and easily pull back any carpet and trim :D

mt audio
15-08-2009, 02:53
if you cant find it in any car follow your bonnet release cable from inside the car up to the bulkhead
running cables down the centre will mean seats up job,there is plenty of room down either side of the car to run them along the sills even for 0awg

OFI
15-08-2009, 23:07
Managed to fight my way through the bulkhead in the top left corner of the passenger footwell in the end! Took me soooo long.

Had to remove all of the air filter system to get to it from the other side!