View Full Version : What will happen when I'll connect the sub to the serial radio!
Surfer_D
15-01-2002, 09:08
Will the screen flicker or something.
I'm planing to connect the amp via converter to the ISO connector and than to the sub.
Are here any side-effects like screen flickering or ???.
Thanks
Icecavern
15-01-2002, 09:34
You should have no problems with the screen flickering but one problem you might have is noise. If you are going to use a convertor make sure it's a good one. I've tried an autoleads one and it was rubbish. Loads of noise from the engine. If the amp you are using has speaker level inputs then use them as they are usually quite good.
Pete
I would definitely prefer the speaker lever outputs of an amp. Installing a level converter will most always induce noise.
as long as you supply the amp direct from the battery and it is not running a silly wattage you should be ok
short CLEAN earth and a power cable capable of supplying the correct ampage is basic firsts
90% planning with ice systems mind
Surfer_D
17-01-2002, 10:00
Ok I'll supply the wattage directly from the battery, but is there a place through which I can put the cables from the motor place into the cabine?
Thanks
Surfer_D
17-01-2002, 10:18
ANSWER FORM KEV HALL;
>In the passenger side footwell, under the dash there's a rubber >gromet you can run the power cables through into the engine >bay. Obviously you'll have to lift back the carpet a bit to find it.
Thanks KEV:cheers:
Dave
Just a word that there is an Earth Poin tin the boot on the left side, next to the light cluster.
Its a factory fitted one, which is nice.