dynatwist help

[wazo]

can some one tell me where to put the air induction pipe for the dynatwist if any one has any photos please put them up

[Garth]

When I had mine, it was stuffed down the wing (where the standard one is) down to the bottom of the bumper.

Bill recommends that you just make it fit the standard location in the foam, by making the hole bigger. IIRC.

[ibizacupra]

My preference (and own position for air feed pipe) is as Garth says.. in the Oe position Foam piece. This is located in the inner wing above the arch liner. You need to remove the foam and cut it to accomodate the much larger Dynatwist pipe. You wil need to shorten the excess hose.

If forward and down low, the cold air feed needs to be held by the cable ties and remember floods and where your air intake is! Too low and drive thru a flood, you will kill your engine.

Hope this helps.

regards
bill

[wazo]

thanks for the info guys much appreciated