View Full Version : How do you change the front fogs?
Hey all,
All I can see is a screw at the front - wondering if anyone had any clever ideas?
Cheers - Rich
------------------
Seat Leon 20v Cupra T
"L3ON CR" Silver and fully loaded
I'm gonna chip it :)
steve.leon
17-09-2001, 19:53
remember reading in the manula that if you wanted to change the front fog light bulbs you could'nt (or at least the manual was not going to tell you how)
be interested to know myslef as I will want to replace the std halo's with Xenon or better b4 the winter sets in http://www.seatcupra.net/forums/confused.gif http://www.seatcupra.net/forums/confused.gif
------------------
Steve
pull the grille trim off and undo the torx screw and the whole lamp pops out , i think there is 2 screws holding it in if i remember , then a cap on the back opens to reveal a spring clip holding the bulb in
hope it helps
------------------
DAZ the AMETHYST parts manager ( flapper@seatcupra.net )
(refreshing the PARTS most other dealers cannot reach)
So - you just 'pull' the grille bit straight out....no undoing of screws first or anything?
Cheers - Rich
------------------
Seat Leon 20v Cupra T
"L3ON CR" Silver and fully loaded
I'm gonna chip it :)
the black grille surround is clipped in , but is real tight , takes a good tug to move it , when its off you'll see the TORX screws holding the fogs in and the screw you see from the outside is an adjuster.
you'll need a strong grip though http://www.seatcupra.net/forums/wink.gif
------------------
DAZ the AMETHYST parts manager ( flapper@seatcupra.net )
(refreshing the PARTS most other dealers cannot reach)