:confused: Has anyone tried to fit a stereo/sub in a Toledo? I cannot find a way of getting the leccy wire through the dash & on the the battery. Any advice would be appreciated. Thanks.
simple-leonR
30-06-2004, 17:59
Don't know about the TOLEDO specifically but the general trend would be to take the front seats out (this gives you more room for manouvre), pull the carpet back (so you can see where your aiming!), and if your lucky you may find a willing hole up around the foot reccess area for your wire. If you don't, then my advise would be to hold the drill steady! Start off by making a small hole throught the bulkhead, then use a bigger drill bit to accomodate the wire, when the hole is large enough, stick a grommet in there, followed by the wire, then if your worried about water leaking in, a bit of silicone seal (or similar) around that (on the engine side). Feed the wire around the engine using cable ties and such, and viola!
That was a very brief overview, if you want more info on it or a complete guide then drop me an e-mail.
http://www.icecavern.com/forum/index.php?showtopic=554&st=0 or follow this thread on ice cavern... I found it most useful :)
Icecavern
01-07-2004, 08:32
http://www.icecavern.com/forum/index.php?showtopic=640 should be that same as the leon ;)
simple-leonR
03-07-2004, 13:23
Wouldn't know yet! Only picked mine up a few days ago!
Off for a week soon tho, so will get my kit in there and let you know how it goes!