View Full Version : 16v induction mod - PPT
Here are a couple pics of my induction mods - following on from Brendy's new filter. As its quite 'Bling' i'm naming it 'PPT' = Posh Pipe Technology, in opposition to SPT :D :)
looks better than those 'real' samco elbows!
where the temp sensor?
You ripped out that resonator with the blue clip on it and the (tech term) plastic bit behind the headlight?
cordobabrendy
27-07-2004, 22:46
have you seen that black thing thats kinda bottle shaped in front of the bumper? theres no hole at the bottom, what a fookin waste of plastic, ive removed it and replaced it with spt laundry piping with a lot of cable ties holdig it open and in place!.
looking good scotty,can i recomend a bit of sheilding on the right hand side?
yup, all the plastic bits have gone, still working on getting a heat shield to fit in - found somewhere that sells universal ones, but I think it will interfere with the cold air feed when it gets in.
The temp sensor plugs through the first piece of blue hose.
:)
Nice , maybe you could list the parts & prices etc.. for other people :)
I have full faith in Brendy ... :)
Oakie doakie;
Samco type hose= manifold to induction pipe £40
Pipe=£15
Hose to filter=£10
2xbreather filters @£10 ish
1xinduction kit @ £30
not exactly cheap, but the noise and revability makes up for it.
:cheers:
Where'd you pick up the Manifold to induction pipe ?
SFS Hoses do a part that will fit, 45 dgree bend 76mm bore. You'll need a breather pipe filter as well, as there's no 'take off' pipe :)
Maximuss
06-05-2005, 17:54
http://www.seatcupra.net/forums/showthread.php?t=48959&page=2&pp=20
and scroll down to my post with the images.
some nice looking ID kits
Scotty_b
10-05-2005, 20:31
cant see any pics mate?