Dr_Ming
09-02-2005, 08:00
I have a mkII Ibiza with the Bosch single point fuel injection (1.6i R4 MONO 1.2.3 D7B).
Using VAG-Com, in measurement group 001, there is a data block called Binary Bits (Bin. Bits). Does anyone know what the individual bits in this block represent?
Basically, I am still trying to fix this:
http://www.seatcupra.net/forums/showthread.php?t=50215
And want to see if the ECU is seeing the switch contact on the idle speed actuator correctly. It is currently throwing up two fault codes related to an intermittent 'no signal' on the throttle position sensor, and an intermittent 'implausible signal' on the throttle position actuator. Looking at the VAG-Com logs, I can always see a valid throttle body angle, but sometimes it does not hold the idle speed correctly (throttle closes to it's mechanical stop @ 5.3 degrees). :confused:
Using VAG-Com, in measurement group 001, there is a data block called Binary Bits (Bin. Bits). Does anyone know what the individual bits in this block represent?
Basically, I am still trying to fix this:
http://www.seatcupra.net/forums/showthread.php?t=50215
And want to see if the ECU is seeing the switch contact on the idle speed actuator correctly. It is currently throwing up two fault codes related to an intermittent 'no signal' on the throttle position sensor, and an intermittent 'implausible signal' on the throttle position actuator. Looking at the VAG-Com logs, I can always see a valid throttle body angle, but sometimes it does not hold the idle speed correctly (throttle closes to it's mechanical stop @ 5.3 degrees). :confused: