View Full Version : 4mm VAC Hose
flashbsd
15-03-2006, 10:15
If i order 3m of red 4mm VAC Hose, is there any chance of you guys throwing in a few 4mm tpieces ? :D
I may also require some of the small hose clips :p
ForgeMotorsport
15-03-2006, 10:16
no probs just add it in the comments box
flashbsd
15-03-2006, 11:39
order placed :D Thankyou
CupraSteve
15-03-2006, 11:46
no probs just add it in the comments box
would this piping be suitable for the vac hose going to the FPR?? heat proof etc?
mine is pretty rotten now
oh, and thanks for upgrading my order for a new spring to a new spring kit for a £1 :D
Steve
I'd be hard pushed to melt that vac hose sitting on the top of the engine, whats the melting point of silicone? Couple of hundred degrees? Be a warm engine if it gets that hot.
I replaced all vac hoses, even the ones to the fpr for your info for a while now, no probs at all. :D
flashbsd
15-03-2006, 12:35
i've got some heat shrink tubing which im going to use for bits that may rub etc, and the bit that touches the head
ForgeMotorsport
15-03-2006, 13:24
The vac hose will be just fine
flashbsd
15-03-2006, 14:15
emailed mark re: order