hi and thanks for the replys.
i wanted to know if AEB engine will fit and work in my audi tt??
can any one
help me out?
thanks
can i put 01 leon
cupra 1800 20vt engine aqx engine in???
will that work?
i need
help
Basically a AEB won't work. It needs to be a 06a block.
Look for AGU, AUQ, AQX, AMK, BAM, etc etc.
As a rule of thumb if the engine comes from a transverse mounted car - Golf mk4, Mk 1 Leon, mk1 Audi TT, Audi S3, then it will physically fit a Audi TT.
There are small differences with the compression ratio's etc with the different engine codes. All the cranks are forged and pistons are forged items (mahle)
The difference are gudgeon pins (wrist pin) size some are 19mm some are 20mm but if your not tuning either would be ok.
The BHP rating of the standard engines i.e 150/180/210/225 isn't set by the engine inside, it's factors like different turbo's intercoolers / mapping etc.
If you not bothered about excessive tuning / and wan't the easiest engine install then i would go with the original engine code, or with a AUQ or similar these 180bhp engines normally fitted with k03s turbos (assuming your replacing a 225bhp version just swap your turbo etc over and bobs your fathers brother
You can pick up AUQ engines for as little as £400 on ebay, if you need one in a hurry then they normally on Buy It Nows around the £5-700 mark.
Hope this
help.