Brakes - SEAT Cupra.net

Kinchy247 · 26-06-2012, 22:55

Hi,
Was just wondering if some one could tell me how easy it is to change front and rear brake pads n disks ive only ever changed disks n pads on a saxo befor so lil bit worried dont wanna start it and break something especialy brembos :s

*TllEWL* · 27-06-2012, 13:02

Fronts are easy ....you'll need a big allen-key / hex socket to lift the caliper off though - I have a feeling it's about 12mm, but do a quick search to confirm

Rears aren't much harder, and there's an excellent guide on here somewhere - again, search bar in the top right corner. You will need to wind-back the rear pistons! Some say you can do this without a tool...I tried once and ended up walking to Halfords to go buy one to finish the job

Kinchy247 · 27-06-2012, 17:24

Cheers very help full

*TllEWL* · 27-06-2012, 17:45

Quote:

Originally Posted by TllEWL

....you'll need a big allen-key / hex socket to lift the caliper off though - I have a feeling it's about 12mm

Given you some duff info here - after checking Google, I found a thread from 7yrs ago on another forum (before they kicked everyone off) where I had this exact same feeling ....and subsequently found out it was 10mm

26-06-2012, 22:55	#1
Kinchy247 Newbie Join Date: Jun 2012 Posts: 6	Brakes Hi, Was just wondering if some one could tell me how easy it is to change front and rear brake pads n disks ive only ever changed disks n pads on a saxo befor so lil bit worried dont wanna start it and break something especialy brembos :s

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

27-06-2012, 13:02	#2
TllEWL Senior Member Join Date: Nov 2006 Posts: 1,195	Fronts are easy ....you'll need a big allen-key / hex socket to lift the caliper off though - I have a feeling it's about 12mm, but do a quick search to confirm Rears aren't much harder, and there's an excellent guide on here somewhere - again, search bar in the top right corner. You will need to wind-back the rear pistons! Some say you can do this without a tool...I tried once and ended up walking to Halfords to go buy one to finish the job

27-06-2012, 17:24	#3
Kinchy247 Newbie Join Date: Jun 2012 Posts: 6	Cheers very help full

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

(View-All) Members who have read this thread : 8
Dyvern, Kinchy247, Muttley, Seanyt, Slimy, TllEWL, vibramfijv, weare138