Triple R splitter

Lucio Bravo

Seat Soldier
Mar 12, 2010
57
0
i have a splitter on my car thats based on the Triple r design, problem is i noticed that when looking at the front end of the car from a distance, the splitter appears to be pointing upward.

I know that the bottom end of the front bumper has a downward angle when running your hand from the outer edge towards the inner edge - hence the splitter now points at an upward angle.

Can any of you gents who have the Triple R splitter on an pre-face lift mk2 Cupra tell me if your splitter appears to also point upward or does it sit reletively horizontal.

best way to gauge it out is to sit on the ground on either side of the front wheels and notice the line the splitter follows from the edge of the bumper near the wheel toward the front of the car.

ps. Kev told me he isnt sure as he has never really bothered to look

crappy pic for reference

2irw8p1.jpg
 

rryans11

MK3 Leon Cupra 290
Feb 4, 2012
238
9
UK
I think mine sat the same way as yours, can't be sure as don't have the car anymore.
 

Kyado

Active Member
Jan 13, 2015
86
0
Hmm, I'm not sure about this. The higher you are when you take the picture, the more it'll look like it's pointing upright. You're above the splitter, so whatever is closest to you will appear to be lower - could just be an optical illusion?

Seems to follow the curve of the bumper.
 
Progressive Parts, performance parts and tuning specialists