Carbon Canister Silicon Hoses Fitting

Yeah iv fitted these and the actual carbon canister hose is too short (hose 6 in ebay pic)

i ended up having to buy extra silicon hose and joiners to extend it to fit, ours is a slightly different set up (i know there listed to fit ours)

Also hose 5 in the ebay pic wont fit on our carbon canister either, i ended up replacing the small hose on top of the inlet manifold with it.

Heres a link which shows where they all should go....

http://www.ttforum.co.uk/forum/viewtopic.php?f=2&t=427562

Hope this helps.

Why not get rid of the carbon canister?

Resistor to fool the system into thinking it's still there is about £2
Screw to block one pipe to the TIP is pennies
Less weight in the bay
Redundant piece of kit after 30,000 miles (IIRC)
Less clutter in the bay
One less thing to possibly go wrong.

You do have to route one pipe down behind the wing (for excess fuel tank pressure or something) but there is hole of that to get it right in there

This is for an LC though, would've though it's similar to the LCR regarding the canister.