toledo limp mode issue - SEAT Cupra.net

malc@heeley3171 · 19-03-2010, 13:59

Hi , my 2002 Toledo 1.9TDI is going into limp mode again after having the MAP and the other devices, vacuums etc replaced about 18 months ago. diagnostics incdicate pressure control problem. I intend to change the 5mm vacuum pipes could there be anything else causing me this grief. Thankyou. Malc

silver surfer · 22-03-2010, 07:53

try removing connection to boost pressure switch in top of intercooler behind offside headlight
check wiring and if connections are clean then refit and try as one on my car it falted and i removed and refitted and has been ok since

malc@heeley3171 · 29-03-2010, 11:25

thanks silver surfer. The cause of the problem finally came to light when I put my foot down. A sudden small bang and loss of pressure - the intercooler pipe had slipped over onto the pulley. New pipe (S/H) now fitted and car runs spot on.

silver surfer · 29-03-2010, 21:03

good to here you got it sorted

19-03-2010, 13:59	#1
malc@heeley3171 Newbie Join Date: Nov 2008 Location: Chesterfield Posts: 4	toledo limp mode issue Hi , my 2002 Toledo 1.9TDI is going into limp mode again after having the MAP and the other devices, vacuums etc replaced about 18 months ago. diagnostics incdicate pressure control problem. I intend to change the 5mm vacuum pipes could there be anything else causing me this grief. Thankyou. Malc

22-03-2010, 07:53	#2
silver surfer Full Member Join Date: Mar 2006 Location: out there over the edge Posts: 277	pressure problem try removing connection to boost pressure switch in top of intercooler behind offside headlight check wiring and if connections are clean then refit and try as one on my car it falted and i removed and refitted and has been ok since __________________ 18 " Toora 950 . MS design front,rear skirts. Seat boot spoiler .Green filter,35mmdrop on eibachs

29-03-2010, 21:03	#4
silver surfer Full Member Join Date: Mar 2006 Location: out there over the edge Posts: 277	boost problem good to here you got it sorted __________________ 18 " Toora 950 . MS design front,rear skirts. Seat boot spoiler .Green filter,35mmdrop on eibachs

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Seat toledo limp mode turbo problem	nathal	Mk1 & 2 Toledo	28	21-04-2010 04:04
Dashboard light, limp mode and struggling to start, can anyone help?	quattrojim	Leon Mk1	4	07-09-2009 18:59
Limp mode Lambda?	DJ-LIAMC	Leon Mk1	9	05-09-2009 16:30
Tdi Leon Cupra - limp mode	merlin051	Leon Mk1	9	01-05-2008 19:49
turbo limp mode wiring fault	stuart edwards	Alhambra	0	09-12-2007 12:32

29-03-2010, 11:25	#3
malc@heeley3171 Newbie Join Date: Nov 2008 Location: Chesterfield Posts: 4	thanks silver surfer. The cause of the problem finally came to light when I put my foot down. A sudden small bang and loss of pressure - the intercooler pipe had slipped over onto the pulley. New pipe (S/H) now fitted and car runs spot on.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

(View-All) Members who have read this thread : 32
5dr, andi leon frtdi, apj, AP_V5, Cheshire_Tom, Dave_88, davidif, David_S14, gezmeister, jason2800, kewe, malc@heeley3171, Muttley, odd-head, osbd1, richardc, ricothedrummer, sgtcortez, shaneseat, silver surfer, Slimy, sssstew, staza, Tartan58, TerrificToledo, thequixotic2001, ToledoNorthEat, Tuvix, vngtx, willives, Yeltzman, zilcho