Gauge fitment

[abbotsmike]

So after my recent turbo failure I want to get an oil temperature and possibly boost gauge. Don't like the idea of A-pillar mounts, and don't really want to lose a heating vent.

Does anyone have any experience with the DIN mounts that I could put in the slot below the radio? Alternatively any other suggestions?

I've seen triple DIN mounts, sure I could find use for a third gauge if necessary!

 

[Cupra_Bod]

Hi mate, I have not done that before but I was looking the other day at possible options and found this, don't know if it is any help??
http://www.ebay.co.uk/itm/WITH-GAUG...arts_Vehicles_CarParts_SM&hash=item337846fb95

 

[R3k1355]

I've fitted the DIN gauge holders from eBay before, no problems with them.

Just make sure you get the correct sized gauge for the holders.

 

[RozzerH94]

is it hard to wire the boost gauges in?

 

[abbotsmike]

I'll probably go down that route then, will report back once I have one!

 

[R3k1355]

is it hard to wire the boost gauges in?

Nah, just splice it into the right wires to get power and illumination when the headlights are on.

 

[RozzerH94]

Nah, just splice it into the right wires to get power and illumination when the headlights are on.

Will be doing that after pay day then!! thanks