I got 1 of those k04-001(DIRECT REPLACEMENT) to replace my blown k03s, had to get a bigger induction hose, then when I came to bolt it to the manifold, 1 of the 3 holes doesn't line up for the turbo to run parallel with the manifold, if I do line the 3 holes up, the turbo sits at an angle causing it to foul against the cylinder head... My question is, Is this simply fixed by drilling out another hole on the turbo so that the third bolt fits???
I've gone so far with it, got pipework and such, so I'd much rather see if it can be done than reverting back to the k03s... If anyone knows anything it would be greatly appreciated, i have seen a bit of mixed views about the k04-001 so tia!!!
I've gone so far with it, got pipework and such, so I'd much rather see if it can be done than reverting back to the k03s... If anyone knows anything it would be greatly appreciated, i have seen a bit of mixed views about the k04-001 so tia!!!
