RR Day @ Westec 209.1bhp and 282lbs/ft

[Daz_gibbo]

Nice one Grant, got the same problem with the laptop I use. The USB ports are handy though!

 

[andycupra]

ill 2nd bill.

282 lbft.... thats seems a rediculous amount of torque

 

[Simon L]

Thats 75% more torque than standard. Whats the limit on a K03?

 

[casey]

i only got 244 ish with same mods at dastek on ko3 last year i was only hoping for around 270 now i,ve got ko3s, i dont have a fmic tho, good results tho,

 

[cuprabaz]

my torque on a ko3s is only 230ish @ 1.1bar. (SMIC)

282 is impressive

 

[Essex_Cupra]

I have ko3 i got 232lb torque just a remap from revo

 

[[email protected]]

Ah ha, got it!!!!

http://www.westecperformance.co.uk/d11pjwrollingroadday.CSV

 

[Daz_gibbo]

Thats promising. Just put the standard airbox back on and it's hitting 145g/s whereas the Dynatwist is 138g/s max. It's a tad dirty!

 

[tackleberry]

Those are some good looking figures phil, well impressed

 

[PhilW]

Nice log there grant. Temps have come down 30 degrees from the last RR day.

Looking at the timing i could advance that a touch and see how it logs.



Daz, you really need to clean that filter by the looks of things, i done mine a while back and it made a huge difference.

 

[m0rk]

Looking at the timing i could advance that a touch and see how it logs.

Look harder

CR of 3.8 suggests it could do with knocking back a bit.

 

[GaryM]

CR of 3.8 isnt that bad is it?
I try to keep mine under 6 and my knock voltages under 20volts.

 

[ibizacupra]

146g/s max.. and that very high torque...

 

[Daz_gibbo]

Which group can you find your knock voltages?

 

[GaryM]

Which group can you find your knock voltages?

Measuring block 026

 

[PhilW]

I thought anything over 5 is bad and retarding.

 

[Daz_gibbo]

Cheers Gary

 

[GaryM]

I thought anything over 5 is bad and retarding.

I suppose it depends on where and how much.
I wouldnt want those figures all over my rev range.

If I was to accelerate in too high a gear then I see figures up to 6CF at the start of the pull which settle back down to 0-3 maximum.

 

[m0rk]

dunno - I go by Revo's SPS3 user guide.... their software, their instructions.

 

[PhilW]

According to my log i'm seeing 4.5 around the 3k mark, about the time of peak torque. Missed that mork, well spotted, .


Torque is very high, and the MAF figure i have never seen over 150 on any of my logs, personal or rr day.