butch20vt
Guest
hope its ok to post this in hear if not please remove.
this is how i did it
polo 6n2 cup holder part number ! 4B0 885 995
first of take the front off there are to screws at the bottom undo them and it should pull off and then unplug the wire on the back.
it will then look like this
then get a flat blade screw driver and pop the coin tray out
so you are left with this
now you will need to trim the plastic back a bit i used a stanley blade
and you will have to trim the front panel
and when you have done that put it all back the same way you took it off and then it should look like this.
and enjoy a can of bow
this is how i did it
polo 6n2 cup holder part number ! 4B0 885 995
first of take the front off there are to screws at the bottom undo them and it should pull off and then unplug the wire on the back.
it will then look like this
then get a flat blade screw driver and pop the coin tray out
so you are left with this
now you will need to trim the plastic back a bit i used a stanley blade
and you will have to trim the front panel
and when you have done that put it all back the same way you took it off and then it should look like this.
and enjoy a can of bow