Hi all,
I have recently encountered the problem of my Ibiza Cupra r 180 engine code bbu throwing codes posted below
16396/P0012/000018 - Bank 1: Camshaft A (Intake): Advance Setpoint not Reached (Over-Retarded)
17559/P1151/004433 - Long Term Fuel Trim Additive Air; Bank 1; Range 1: System too Lean
These codes were found with vagcom and show up as intermittent faults, I have also noticed that my car will also sometimes misfire on cold start and periodically looses boost.
The car has been mapped before I purchased it, it also has a 4 bar fpr, ecs screwdown coil packs, n249 bypass, sas bypass, decat and full exhaust, k and n filter, upgraded fmic and forge silicon hoses and a bov
I have recently changed the maf sensor and plugs and this did not seem to fix the issue of misfiring and loss of boost
Any help or advice on this situation would be greatly appreciated
I have recently encountered the problem of my Ibiza Cupra r 180 engine code bbu throwing codes posted below
16396/P0012/000018 - Bank 1: Camshaft A (Intake): Advance Setpoint not Reached (Over-Retarded)
17559/P1151/004433 - Long Term Fuel Trim Additive Air; Bank 1; Range 1: System too Lean
These codes were found with vagcom and show up as intermittent faults, I have also noticed that my car will also sometimes misfire on cold start and periodically looses boost.
The car has been mapped before I purchased it, it also has a 4 bar fpr, ecs screwdown coil packs, n249 bypass, sas bypass, decat and full exhaust, k and n filter, upgraded fmic and forge silicon hoses and a bov
I have recently changed the maf sensor and plugs and this did not seem to fix the issue of misfiring and loss of boost
Any help or advice on this situation would be greatly appreciated