A few codes can sombody shed some light

[gavbey]

hi guys,

i have a stage 2 cupra. before the winter its was all good. beeen in storage for a good few months and shes not running to great.

on WIDE OPEN THROTLE its fine untill around 4k then it cuts out and backfires.

i have these codes. has anyone had this before? ive ordered new plugs and lambda sensor.

16518 P0134 O2 Sensor Circ.,Bank1-Sensor1 No Activity Detected
16955 P0571 Cruise/Brake Switch (A) Circ Malfunction
17524 P1116 O2 Sensor Heater Circ.,Bank1-Sensor1 Open
17748 P1340 Crankshaft-/Camshaft Pos.Sens.Signals Out of Sequence
18010 P1602 Power Supply (B+) Terminal 30 Low Voltage


thanks very very much in advance

 

[typergaz]

First of all make a note ofd all your faults then clear them to see which are ghost faults, clean up all the connections on the tray that sits on top of your battery an check all your earthing points

 

[gavbey]

First of all make a note ofd all your faults then clear them to see which are ghost faults, clean up all the connections on the tray that sits on top of your battery an check all your earthing points

done that before i got these faults,

new lambda should be here tonight so ill see what its like after ive fitted that,

thanks for the comment tho gaz

 

[gavbey]

i have replaced lambda and coolant sensor (just incase)

i now have this error

17748/P1340/004928 - Camshaft Position Sensor (G40) / Engine Speed Sensor (G28): Incor. Correlation

still cutting out under high load.

also it runs better with the maf unpluged but still cuts out! arghh

i have vag com. i am going to log 15 and 20 tonight. (its hard to do with no front end)

any other advice? has anyone had a similar problem?