Engine Management light P10AA

[5erious5am]

Hi

My engine management light came on a few days back and I've had it scanned and it came up with Engine code P10AA after scrolling the internet and the forum I have not been able to find much about it.
I found one foreign site that when translated said it could be the supercharger clutch not closing.

Has anyone had this code before or have an idea of where to start with it?

I did reset the code but came back on the following day.

My car is a 2010 Ibiza Cupra.

Any info would be greatly appreciated

Thank Sam

 

[IvoLour]

Hi
Does your car go into limp mode?
I had a similar problem, only the code was p10AC and had to replace the waterpump as the magnetic clutch that operates the supercharger is a whole with the waterpump.
Best regards

 

[5erious5am]

Hi
Does your car go into limp mode?
I had a similar problem, only the code was p10AC and had to replace the waterpump as the magnetic clutch that operates the supercharger is a whole with the waterpump.
Best regards

Doesn't go into limp mode but did notice after writing this post that the car is leaking coolant rapidly which seems to coming from the water pump pulley so I've booked it in for the pump changing. All seems to make sence now with the fault code coming up and the pulley seems a bit noisey too

 

[IvoLour]

The bearings inside the pump must have shatter or something. It does become noisy