Just had front tyres changed and tracking done but they couldn,t do camber .
The before settings were -LEFT camber , -1.00 deg , toe 5.8mm
RIGHT camber ,-1.40 deg , toe 3.9mm
After settings -LEFT camber ,-1.20 deg , toe -0.7mm
RIGHT camber ,-1.50 deg , toe 0.80mm
Would those before settings produce outside edge tyre wear ,more on Left tyre , and are the new settings about within tolerance ?
Any suggestions for the hub/strut bolts settings eg tighten bolts when they are centered ,as can,t get car booked in for camber check for over a week .
What started out as £20 for wheel bearings is turning into an expensive job .