These are high-quality OEM grade car badges (tested by Citroen and Mercedes) made from real bronze coloured with hard enamel colouring.

They are mounted using 3M rear tape.

Dimensions

Width: 70 mm

Height: 16 mm

Weight: 26g

Fitting guide

1 - Choose your ideal location
Members have put theirs below the FR or CUPRA badge, or on their number plate, or inside next to the gear stick, choose the spot that works for you. You can test areas of placement by putting a bit of blu-tak on the back of the badge before peeling off the tape backing.

2 - Clean the area
Ensure the area you are affixing the badge to is clean, and ideally not freshly waxed.

3 - Remove the backing of the 3M tape
Peel off the backing to reveal the sticky side of the tape ready for application.

4 - Place badge
After carefully lining up the badge press it onto the car, holding it for about 10 seconds to ensure it has firmly stuck.

5.- Be sure to share your photos in the merchandise forum