Most orders include freebies and delivery is included on most items.

Copper Car Badge (OEM Quality)

SKU 00016
In stock
Product Details



The items won't be in stock until we have 50 pre-paid orders and then commission them to be made- full details in this thread

  • For orders of two badges the postage charge should be automatically deducted. If you want more than two badges, please email [email protected]
  • If you are outside of the UK, we will ask you to pay the additional postage charges separately.
  • The copper has been soaked in Iron/Fallout remover for two hours with no sign of damage. However, your use of chemicals on the car and the badge are at your own risk.


These are high-quality OEM grade car badges (tested by Citroen and Mercedes) made from real brushed copper coloured with hard enamel colouring.

They are mounted using 3M rear tape.


Width: 70 mm

Height: 16 mm

Weight: TBC

Fitting guide

1 - Choose your ideal location
Members have put theirs below the FR or CUPRA badge, or on their number plate, or inside next to the gear stick, choose the spot that works for you. You can test areas of placement by putting a bit of blu-tak on the back of the badge before peeling off the tape backing.

2 - Clean the area
Ensure the area you are affixing the badge to is clean, and ideally not freshly waxed.

3 - Remove the backing of the 3M tape
Peel off the backing to reveal the sticky side of the tape ready for application.

4 - Place badge
After carefully lining up the badge press it onto the car, holding it for about 10 seconds to ensure it has firmly stuck.

5.- Be sure to share your photos in the merchandise forum

Save this product for later