bxe

Hi Guys, Seat Leon 2008 1.9 TDI BXE. I recently suffered conrod failure in my BXE engine where the conrods have smashed through the bottom engine block. I'm doing a conversion from the 1.9tdi BXE engine to the 1.9 TDI PD130 ASZ engine as there is no point putting the same engine in for the...

Hi All, I have just had the dreaded conrod failure on the 1.9 TDI BXE engine in my 2008 Leon. No warnings or anything, just a sudden breakdown on the Motorway. I do want to get this back on the road as I've put a lot of work into the car so I know all other aspects of it are sweet. Just...

i have an issue with my Seat Leon 1.9 TDI 2008 retaining engine temperature. I have performed an EGR delete using a blanking plate and it appears the warm up time now is now significantly slower than it was before. Once the car reaches 90 (without the heaters on,) if I'm sat idling and then...

Went for a steady remap earlier on today which took my car to about 135/140 bhp by a highly respected tuner in my area and as I pulled off of the street I have it some in first and second and car went in limp mode followed by a cloud of blue smoke turned car off and waited for it to be...

Hi all, I’ve a 2009 mk2 Leon pre facelift very basic model Was looking to upgrade to a double din that’ll allow use with apple play. What radio, fascia and wiring looms do I need, have multifunctional steering wheel and want to be able to use it to control the radio Thanks

Hi, This issue appeared when I bought this car. Whenever you start engine it kick hard and you can feel on gearbox knob if you hold. This is really hard kick. What I have changed after owning this car teo years: Starter. Didn't help much. No effects. Clutch. More effects but still appear every...

I've heard it's the new code for the older BKC engine but i'm only interested in the cylinder head and if it'll fit onto an ASZ lump, obviously after changing the injectors over. I know the BKC will fit but i'm not sure if the BXE head is exactly the same as it's a newer code and might have...

Was looking at getting the Oval exhaust trim fitted to the Altea, just to finish off the rear instead the standard round boring pipe. Upon further investigation, the trim is not available/suitable for the BXE engines. WHY ???????