Help Help!

[gus]

as some of u no my engine and traction light came on yesturday, had it checked out and this come up:
17833/p1425 035 evaprative emmision canister purge valve
17955/p1547 035 turbo wastgate solinoid(a): low input short to ground
17843/p1435035 secondary air injection system pump relay cuircut short to ground
17829/p1421035 secondary air injection (air) solinoid valve
17525/p1117035 h025 heater curcuit bank
16518/p134035 02 sensor
16486/p010235 mas sir flow low input

HOW GUTTED WAS I TO SEE ALL OF THAT DO U HAVE ANY IDEAS OF WHAT HALF OF THESE THINGS ARE?

I WOULD BE VERY VERY GREATFULL

THANKS
GUS

 

[m0rk]

clear them & see what comes back

 

[gus]

help help!!!!!!

did that they were the ones which kept on popping up!!!! aaaaarrrrrgggghhhhh

 

[m0rk]

check that you've not got water all over your ECU plug, and that you've not burnt some of your wire

 

[gus]

help help

contacted warrenty place they advised me to go to a garge send them fault codes and see what they can do but bet i gues alot of those things wont be covered?????????

what do u suggest?

 

[ibiza-cupra]

i had a load of fault codes on a vehicle with a dodgy lamda sensor

 

[TimD]

Check fuses..

 

[gus]

help help

will do guys will c wats up with it and get back u all of u many thanks just hope its nuthing major

gus

 

[TimD]

I got similar errors when i melted a connector. Just had the connector replaced, replaced a fuse and all is well

 

[gus]

help help

where was that conector as i have found a contector bit frazzeld at the back top of the engine, where it it sits on 2 rubber gromits?

 

[TimD]

that one, mine had dropped onto the turbo/manifold and melted beyond recognition.

Have you burn any fuses?

 

[gus]

help help

that the one it dropped down and has frazzled a bit that wat happened to urs wat does that control? i

 

[TimD]

It's part of the N249 so i think it's to do with boost.

Unless it is fully melted i wouldn't worry about it, just check your fuses, lol! I had the wiring replaced and was still getting errors until i replaced a 10A fuse!

 

[gus]

help help

ok dudes thanks alot for ur imput will check it out tomorow

gus

 

[gus]

help help

sorted boys replaced the fuse and it runs fine apart from ecu light still one and the air mass requires replacing. think other things like air injection solinoid waste gate solionoid

 

[ibiza-cupra]

where was that conector as i have found a contector bit frazzeld at the back top of the engine, where it it sits on 2 rubber gromits?

there you go happened to mine too,and must be about 99% of others!

 

[gus]

help help

i require a new maf but wud the ecu light come on for that if there was a problem just for that? what about all the other faults which were written down?

 

[TimD]

Have they gone?

 

[gus]

help help

replaced fuse and traction klight gone but ecu light stil on, i no i need anew maf, but wud the ecu light still come on for the faulty maf?

 

[m0rk]

Yup