My Fault codes, zeee maf is dead i tink!!

[Russ_20vt]

Finally got Vag-Com and as suspected i think my MAF is R.I.P, did a few runs and the maximum mac flow i achceived was 122gs, im on stock air filter. From searching i should be seeing 150ish right?

The codes:

17968 - maximun engine speed exceeded

17536 - Fuel Trim: Bank 1 (Mult): System too Lean

18010 - power supply (B+) term 30 low voltage

16486 - Mass Air Flow Sensor : Signal too Low


The car is still boosting happily to 15 psi and im not getting limp mode.

Any ides chaps?

Thanks

Russell

 

[Martyn]

Yup, it's toast

 

[DPJ]

To borrow from Python,

It's not pining, it's passed on. This MAF is no more. It has ceased to be. It's expired and gone to meet its maker. This is a late MAF. It's a stiff. Bereft of life, it rests in peace. If you hadn't screwed it to your TIP, it would be pushing up the daisies. It's metabolic processes are now history! It's kicked the bucket, It's shuffled off it'smortal coil, rung down the curtain and joined the choir invisible!

 

[Saul]

The codes:

17968 - maximun engine speed exceeded

how did you get this one?

it wont clear btw, just in case you wonder

 

[Russ_20vt]

She lived a short but happy life, the 35k she travelled was an epic adventure that will stay in our hearts forever.

R.I.P

Mrs MAF

 

[Russ_20vt]

Oh Saul, from reading up thats the rev limiter. As my rev limiter was removed when mapping, though i have no idea as i only rev my car to 6k anyway? im not to worried about that one.

 

[Simon L]

how did you get this one?

it wont clear btw, just in case you wonder

It will. As i have had the code before, and cleared it.