Reversed into a brick wall :-(

[foad88]

Hey,

I was a numpty and reversed on a low brick wall.

Scuffed the lower bumper and the under bumper has slightly come out of place.

How can this be placed back.. wacking doesnt work, and the hinges clip back, but nothing happens

 

[lil3520]

No parking senses on your motor ?

Andy

 

[foad88]

I do have sensors, they work fine until you get closer to the wall and then silence.

The sensors are just above the wall

ive been parking fine for last 5 months.. just was too quick .. ahh :-(

 

[Bubbs]

Ouch.

I backed into a trolley bay a couple of years ago, sensors picked it up, but I went by my eyes instead and.... sensors won :/

This diagram might help :

http://www.oemepc.com/seat/part_sin...807/subcategory/807050/part_id/1395890/lang/e

It looks like your #3 bit is in its original position, but the blue bit is now pushed in. So, I think you might have to take the black bit (#3) off and 'encourage' the painted part to accept it again upon refitting.

As to 'how'... well, I guess it's a case of undoing the bolts at the points where they're marked on the exploded diagram and wiggling/pulling/praying a little.