revs when chaging gear

[richy850]

misses says that her car revs up a little when changing gears.

amy body any ideas ?

thanks

 

[Mr OCD]

misses says that her car revs up a little when changing gears.

amy body any ideas ?

thanks

They all do that sir ... (well not quite revs up but they do hang a little)

It's to help smooth gear changes out ....

 

[Alexis27]

Yep, mine does that.

 

[NickT]

Could be the clutch pedal switch packed up, mine has and it sounds like the engine revs 'hang a little' when I change gear.

Apparently the clutch pedal switch is supposed to cut the fueling/revs during gear changes as well as work with Cruise when fitted.

Here's a quote from Audiworld forum:

per the Bentley manual, the function of the Clutch Pedal Position switch (aka Clutch Vacuum Vent Valve Switch):

This signal is used to avoid RPM over-oscillation and load change impacts when changing gears and is also used for the cruise control system.

 

[richy850]

any ideas on cost and location of switch

 

[LEE69]

Switch might be on the clutch pedal

 

[richy850]

ok have to look tomo its realy bad when u give it a bit ....

 

[Phoenix27]

Try an N249 bypass..... solved this for me....

 

[cupra-barn]

Mine does the same will try the n249

 

[richy850]

how easy is n249 mod to do any step by step pis ??

 

[LEE69]

Use the search, the info is out there on about 3,000 threads!!

 

[Phoenix27]

 

[richy850]

can some one take a pic of where this clutch switch is for me ?

 

[NickT]

Check the last picture in this thread, it's the blue switch on the clutch pedal, rather unsurprisingly.

http://www.seatcupra.net/forums/showpost.php?p=1607721&postcount=1

 

[richy850]

many thanks will try have a look today

 

[adam_lincs]

my mum always revs when changing gear and also when setting off in 1st - it aint no clutch switch tho i tell ya!! lol

 

[richy850]

found switch easy didn't have to take any of underdash out.. switch is stuck in so order a new one £10.47 + vat will fit tomo

 

[NickT]

Just out of curiosity did you have a EML fault code for this?

 

[richy850]

no m8 i didnt but the switch was just pushed in and was very stiff to pull out so ordered new one

 

[richy850]

switch fitted probelm solved