I'm case this information can help someone...
5 days old V2 52kwh Plasma paint. Sat in my works car park. Stationary... This error about the wheel lock pops up. Unable to start the vehicle.
Cupra assist/AA turn up, try all sorts of troubleshooting that I had tried. Chargin the 12v battery a bit more. Picked up on the next few days by a cool recovery robot and returned to the dealer.
Firstly they messaged me wanting £432 to remove the steering wheel aid communication box wired into the CAN bus, that they themselves sanctioned a third party to install for us, suggesting it might be the cause of the fault.
Eventually they agreed that I didn't have to pay this. Ordered a replacement "Steering wheel lock module" and have fitted it. But they have also removed the steering aid wiring, meaning my wife with disability in one arm can't drive it. They are arranging to get it fitted again, assuming at no cost to myself. And I'd already seen online that people had had this error without a steering aid control fitted! You'd think there would be some issue and resolution database with Cupra that they could consult but feels like there isn't when you have more knowledge about the issue than them!
Anyway, hope to pick it up in the next day or so, then back in again to get the aid re-wired. Hope to not have any more issues going forward!
On a positive note as seen on the image my dsg oil, timing belt and haldex 4x4 oil are all in good health
5 days old V2 52kwh Plasma paint. Sat in my works car park. Stationary... This error about the wheel lock pops up. Unable to start the vehicle.
Cupra assist/AA turn up, try all sorts of troubleshooting that I had tried. Chargin the 12v battery a bit more. Picked up on the next few days by a cool recovery robot and returned to the dealer.
Firstly they messaged me wanting £432 to remove the steering wheel aid communication box wired into the CAN bus, that they themselves sanctioned a third party to install for us, suggesting it might be the cause of the fault.
Eventually they agreed that I didn't have to pay this. Ordered a replacement "Steering wheel lock module" and have fitted it. But they have also removed the steering aid wiring, meaning my wife with disability in one arm can't drive it. They are arranging to get it fitted again, assuming at no cost to myself. And I'd already seen online that people had had this error without a steering aid control fitted! You'd think there would be some issue and resolution database with Cupra that they could consult but feels like there isn't when you have more knowledge about the issue than them!
Anyway, hope to pick it up in the next day or so, then back in again to get the aid re-wired. Hope to not have any more issues going forward!
On a positive note as seen on the image my dsg oil, timing belt and haldex 4x4 oil are all in good health
Attachments
Last edited: