wideband (AFR) lambda advice

[mc funbot]

hey guys well my car is soon to be back on the road looking in to getting a oil temp gauge an a afr gauge.. seen a few an looked in to a few just wanted a little help on whos got what i dont have a huge budget..
so the wideband goes in to the 2nd lambda on my exhaust.the lambda that should go there i keep connected an just tuck out the way yes??
just a little help please you lovely folk of cupra.net

ive seen this

http://www.ebay.co.uk/itm/300493875519?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

is anolog better than LED?

http://www.ebay.co.uk/itm/120849186283?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

 

[chaazza]

As far as I was aware you keep both lambas and have your dp drilled and put it in the new whole

 

[cuprawill]

I was told closer to the turbo is ideal but it can be run at the rear lambda but the internal heater of the lambda will always be running

 

[Berg]

The wideband sensor wont be as accurate in the second hole as it needs to be quite close to the turbo

Best bet is to get a weld on boss (comes with most wideband gauge kits) and have that welded onto your downpipe thats what i did when i fitted mine

 

[mc funbot]

Cheers guys whats the fitting situation easy or hard work wires everywhere?? Putting another boss in is not a problem!

 

[Berg]

Nope its easy it will be one red for live and one black for earthing, the rest will be bulked together with a plug on the end and go to the sensor

 

[mc funbot]

Sweet berg look forward to you fittin it. Hahahah will make you a cuppa.. Yer so led or analog?

 

[mc funbot]

so to put this other boss in should i put a boss in after the 1st lambda about 16" from the turbo i was told?

 

[Berg]

Haha prefer beer

Yer thats where i had my boss welded on before the first lambda

I would go for the led one, never seen anyone use an analog before

 

[mc funbot]

so we shall go with this then?
http://www.ebay.co.uk/itm/120849186283?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
ill get on the case mate! thanks for your help an ya always welcome for a beer.

 

[Berg]

Yep looks good to me :d

Quite a few running that kit on here

 

[mc funbot]

sweet well i better pull my finger out an get one sorted an give my dp to my brother to weld haha

 

[fourtwofive]

Good choice I have one on my ever growing list

 

[mc funbot]

Dp off today mock up for new lambda boss brother can weld it tomorrow

 

[Berg]

No messing lol

 

[mc funbot]

Well engine should come back tomorrow if I finish it. Did a little update last night on the thread