X Reg Cordoba Sx 16v Project

woodlehouse

Active Member
Mar 1, 2008
102
0
billingham
HI

put a few pics in teh newbie section
http://www.seatcupra.net/forums/showthread.php?t=162724


started the modding already

got myself a race spec engine to detailup & eventualy fit

taken out of a polo classic saloon race car
polotrackcar003.jpg


tsr a pack big valve ported & gas flowed cylinder head
kent blank cams reprofiled to tsr 1604s (head machined to allow cam to spin)
kent vernier pully
bottom end lighteded & balenced
inlet manifold ported & flowed to match head
xxl dynatwist green induction filter

bizengine1015.jpg

bizengine1016.jpg

bizengine1017.jpg

bizengine1018.jpg


should be beast when done , last rolling roaded at 178bhp @ wheels with 020 rod box with quaffe diff , will be running it on a 02a cable box as in corby with all acfited & pas so will have to see :D
 

Saul

<b>SCN Admin</b>
May 21, 2001
4,194
0
how much did that go for in the end? or was it pulled and stripped?

was after the engine myself lol :D
 

woodlehouse

Active Member
Mar 1, 2008
102
0
billingham
some more pics that have been taken

not sure about the de-badged grill ..................bit saxoy :cry: but hey better than rabbit hutch mesh :ban:


pics007.jpg

pics008.jpg

pics006.jpg


:drool:
 

Cupra_Jay

Orange Wheels FTW!!
Oct 25, 2006
919
0
Pub!!
looks good mate, cudnt u have fitted a bigger induction kit though....that cone looks pretty small!! lol

whats the 0-60 on this??
 

woodlehouse

Active Member
Mar 1, 2008
102
0
billingham
looks good mate, cudnt u have fitted a bigger induction kit though....that cone looks pretty small!! lol

whats the 0-60 on this??


its just stock at teh mo with the silly small induction on , i havent yet fitted the race spec lump yet , cant be bothered yet and ned to strip it down & powdercoat manifolds & paint up the block [B)] + need to find a 4 branch to run it through with a good exhaust