bent

Well last night the snow/ice made me slide into a kerb at low speed & its made my tracking toe out. After further inspection the Near Side Front control rod is bent. How much roughly do you think it would cost for the part & labour (1.2 sx). I hope you can get the control rod on its...

Does any one know the affects of a bent subframe. I have been advised that I may have this problem, i have had new strut, new knuckle, hub bearings etc, laserlined tracking but its still pulling to the left and massive tyre wear on the right hand tyre. also any ideas on who can fix this, im in...

I know peoples opinions on these arent great but ordered a set before I really knew. Got them fitted on Sat night and everything was dead on until the dreaded passenger side noise appeared. Under inspection tonight I can see that theres alot of movement in the coils but most worrying is...

Hello baught an arosa a few weeks ago light front end damage and had all repairs done, went to get the tracking done the other day and turns out the front subframe is bent causing the front passenger wheel to sit just over an inch further backwards than normal:( anyone recomend were i can get...

Hello guys, Im looking for some information on a tie / steering rod (highlighted red) and hopefully a part number as its a part I require to get my car back on the road. The wishbone was bent - now replaced. However I still require to get a tie rod to get the car back on the road. Please see...

so i crashed the other day, not much damage got pics .... so took it all off, went scrappers and then got there, looking for the front end, thought polo was same, so lookin at that, its not, so founds a corby (1.6 with aircon lol might nab the whole system for mine lol) trying...

Just taken car to be tracked today as I noticed some uneven wear on the rear tyres. Unfortunately I've found out that the rear axle has bent so needs a new axle:( Previous owner must of curbed it pretty badly. Just wondering if anyone else has done this sort of job before/ knows the sort of...

Any ideas on a price? i'm 95% sure ive bent a rod when ingesting water last weekend.. :cry:

hi just thought id show the pics of my con rods ive changed this weekend there from a bam engine thats not even done 20,000 mods are forge tip itg filter no cat large front mount cooler revo stage1. one rod is the worst but all 4 are bent

Right, ive just gone round a corner just after it started raining, lost it and piled my car into the curb at about 25mph :censored: I now have a very bent wishbone and no reverse gear! Anynbody know why no reverse? has the shaft been forced into the box and ruined reverse? Anybody know...

Was out cleaning my car this morning and spotted to my horror that my front near side wheel was sodding bent: I think I know when it happened, went down a huge pothole on a very narow road thanks to an equally huge lorry. Didn't think anything of it at the time aside from the large bang -...

this is starting to pi** me off now it lets the look of the whole rear end down. basically my fr exhaust is sagging one side and looks rather low( miles from the bumper cut out) has anybody else had an exhaust like this as ive seen a few like it. im thinking of heatingh up the sagging tail pipe...

Here is the history. The car is a 2002 Seat Leon Cupra. 1. Purchased car from main dealer. Noticed that tracking etc is fine, but steering wheel requires around 30 degrees of clockwise turn when the car is in a straight line. 2. Dealer has a go at fixing it while I wait. End result -...

Anyone from here? http://cgi.ebay.co.uk/SEAT-LEON-CUPRA-R-2004-BREAKING-BREAKING-ALL-SEAT-LEON_W0QQitemZ4599451153QQcategoryZ100918QQrdZ1QQcmdZViewItem