348 lb/ft stage one?

[lee wwfc]

Right then thanks at least i know it’s a dodgy map lol. Just more of an excuse to go stage 2 i suppose!

 

[turbomick]

This was mine at stage 1 mate

Was was this print out done mate looks same as mine

 

[WeeG]

The torque vs hp vs rpm scaling is very poor, but there is nothing wrong with that map.

 

[Hurdy]

The smoothness of the graph of power and torque can vary from dyno to dyno depending on the dyno make and software used.
Dyno dynamics tend to give smoother graphs than most and if your plot is bad on one of them then it definitely is a bad map.
The torque comes in very late on the OP's graph, should be 3.5-4krpm for peak torque with a k04.

 

[lee wwfc]

I really don’t know much about dynos or the graphs but it doesn’t seem to drive terribly, then again this is my 1st car that’s been mapped so can’t compare it to anything.
As long as it isn’t harming the car?