Cordy has a bit of a problem when accelerating hard using the full rev range, which is generally only apparent in 2nd and 3rd (prob more due to the nature of my acceleration than anything else)
Let's say I accelerate to 4K revs in 2nd before changing up to 3rd, when I've changed up and reapply the accelerator, there will be no acceleration for a few seconds, then it kicks in. During this time it's as if the engine isn't pulling, and it's being retarded. Pressing the accelerator doesn't increase the revs by much at all during this time, and there is no boost from the turbo.
After the few moments have passed, normal operation is resumed.. until let's say I then rev in 3rd in the 3-5K range and change to 4th.. where the retardedness returns again.
It seems as if the engine goes into a 'limp mode' momentarily after being in the higher rev range following a sudden easing off the accelerator.
There are no fault codes logged whatsoever.
Any clues?
Let's say I accelerate to 4K revs in 2nd before changing up to 3rd, when I've changed up and reapply the accelerator, there will be no acceleration for a few seconds, then it kicks in. During this time it's as if the engine isn't pulling, and it's being retarded. Pressing the accelerator doesn't increase the revs by much at all during this time, and there is no boost from the turbo.
After the few moments have passed, normal operation is resumed.. until let's say I then rev in 3rd in the 3-5K range and change to 4th.. where the retardedness returns again.
It seems as if the engine goes into a 'limp mode' momentarily after being in the higher rev range following a sudden easing off the accelerator.
There are no fault codes logged whatsoever.
Any clues?