Adeyspec LCR now Badger 5 stage 2

[joshy514]

Ahh cool, a good mate of mine used to work at schlumberger (spelt right?). I'm in Tuffley when I'm home, should have an LCR meet some point as there are a few I know of in Gloucester. Bill will be stage2ing mine if he will of course, I wouldn't use anyone else apart from Nikki but he's quite far away. I pick stuff up from forge too, a lot cheaper than the internet I think my 007p was £80 over the counter.


Sent from my iPhone

 

[adeyspec]

Schlumberger is the one yeah. He not still work there? Yeah defo, see a fair few flying about here

 

[joshy514]

Last time we poke about work he said he was leaving to work at a place in Worcester. Alex Paterson, know him?


Sent from my iPhone

 

[adeyspec]

Nah not heard of him though there are 5 buildings down here

 

[joshy514]

You say you're from Hucclecote, my brothers girlfriend lives there, is there a red one by you? Apparently it's well looked after, parks down one of the turn offs off that road with like 13 speed bumps, forgotten the name though. It's got the garage at the end where all the National Express coaches fill up?


Sent from my iPhone

 

[adeyspec]

The only one I see close by is a grey one outside the bookies. Not seen a red one about.

 

[bully]

today was spent prepping the car for mapping on weds. new spark plugs one stage colder and fuel filter thrown on and fitting the b5 tip properly, it was on the car when i purchased it but it wasn't sealed or locked on so that was also done. Prosport coilovers were also fitted to replace the worn out stock setup, i had a broken rear spring so for me it was a good upgrade. rides really well now though i havent slammed it. its probably 25-30mm off stock height though i dont think it will go any lower without spacers. She needed shorter droplinks fitting so mercedes vito items were fitted

MERCEDES-BENZ VITO 113 2.0 PETROL (03/97 - 07/03)

ANTIROLL BAR LINK / DROPLINK - FRONT LH
PART NO : 427ME0260

ANTIROLL BAR LINK / DROPLINK - FRONT RH
PART NO : 427ME0270

Part numbers for anyone who searches and finds this.


Looking forward to weds now for a proper mapping sesh and ill get the car cleaned up for some decent shots.

hello there ! fitted prosport coilovers today with vito droplinks from euro car parts but they're rubbing against the driveshaft ! they measure 230mm from centre of ball joint to centre of ball joint ! can u remember what yours measured ? thanks !