breather pipe modification

[vngtx]

im getting so sick of oil all over my cam cover so - has anybody ever used silicon instead of the original pipe? i was thinking of putting it between where the pipe splits at the side of the timing belt cover to the cam cover inlet and between the air pipe and the cam cover inlet.

 

[Fl@pper]

always been a a right 'mare that hose

would it be possible to use 2 single pipes instead of the original where that double fitting is ?i know gates make some push fit elbows that may start it off ?

i'm thinking of the elbow in the centre >? then run 2 straight hoses off that

 

[vngtx]

im thinking about 4" pipe from this half to a 45* elbow then a small pipe (1") to a 90* elbow then another snall pipe into cam cover inlet.

why didnt Seat just use a proper pipe instead of what feels like foam