-
Guest, New Stock alert: Premium CUPRA valve caps now available in the store ? Order now from the merchandise store
Fitting facelift tail lights
- Thread starter lawrieIbizaMk4
- Start date
Lawrie, would you be able to send me that guide, I'm hoping to do this to my Boc too they look awesome! [email protected]
Hi LawrieIbizaMk4, those lights look really awesome. Can I bother you to send me the guide please to [email protected]
Once again thanks in advance
Once again thanks in advance
Hi, I wired them to the interior light as I didn't want to go near any wires in the fusebox plus they fade in and out in time.
I took interior light out to expose the hole in the roof (2xtorx screws) and took N'S sun visor off, I then used a cable routing tool to feed the cable to the A post of the N/S (you will see that the roof lining meets the windscreen, it will pull away enough to get the cable to the A post trim).
I then fed the cable behind the trim between the door rubber and dash trim down and along by the N/S door to the footwell. I basically wired them from the interior light, positive cable on one side of the main bulb connector and neg on the other as the Led's have + and - circuit. You don't need to solder or cut just put cable through the hole and attach cable to the bulb mount and let the interior bulb hold it in place.
I used bullet connectors to join the lights together and plugged into the feed cable. The LED lights fit under the dash trim and have sticky pads which seem to hold into place really well although I used a couple of zip ties just to stop them from dropping should the adhesive fail at a later date.
I got them from www.alltronix.co.uk on ebay
Hope that helps, if you want images I can e mail them to you.
I took interior light out to expose the hole in the roof (2xtorx screws) and took N'S sun visor off, I then used a cable routing tool to feed the cable to the A post of the N/S (you will see that the roof lining meets the windscreen, it will pull away enough to get the cable to the A post trim).
I then fed the cable behind the trim between the door rubber and dash trim down and along by the N/S door to the footwell. I basically wired them from the interior light, positive cable on one side of the main bulb connector and neg on the other as the Led's have + and - circuit. You don't need to solder or cut just put cable through the hole and attach cable to the bulb mount and let the interior bulb hold it in place.
I used bullet connectors to join the lights together and plugged into the feed cable. The LED lights fit under the dash trim and have sticky pads which seem to hold into place really well although I used a couple of zip ties just to stop them from dropping should the adhesive fail at a later date.
I got them from www.alltronix.co.uk on ebay
Hope that helps, if you want images I can e mail them to you.
Can I have a guide too please? please if anyone have this please send me
My email address is [email protected]
Thank you!
My email address is [email protected]
Thank you!
Hello. I've got Ibiza SC 3D 2011. Could you send me the guide for tail LEDs to email [email protected]. I'll very appreciate. Maybe someone know about adaptation these tail lights, curently they are very bright. I think better decrease bright.
Γεια σας από την Ελλάδα. Μπορείτε να μου στείλετε email σε αυτό το email για να σβήσω και την προειδοποιητική μου λυχνία ([email protected]);
Thank you very much for your time and your support
Similar threads
