Front Hub Nut Torque Settings

[M20FES]

Been looking around on the internet and getting different figures for the torque settings for the front hub nut, some saying 200Nm and some saying 300Nm which is a big difference

Anyone know the actual Nm figure ?

 

[brad_barker12]

Note Haynes torque settings for the nut are:
Stage 1: tighten to 200Nm
Stage 2: Slacken by one half-turn
Stage 3: rotate wheel one half-turn
Stage 4: tighten to 50Nm
Stage 5: Angle tighten through 60 degrees

 

[brad_barker12]

^^that's what my mate matt did when doing my CV boot repair.

 

[M20FES]

Note Haynes torque settings for the nut are:
Stage 1: tighten to 200Nm
Stage 2: Slacken by one half-turn
Stage 3: rotate wheel one half-turn
Stage 4: tighten to 50Nm
Stage 5: Angle tighten through 60 degrees

ok thanks

if you originally tighten itt to 200Nm then rotate then again at 50 Nm surley it wont move anyway, or is that 50 Nm more i.e. 250 Nm

 

[BigJase88]

Your slackening it off half a turn so not long at 200nm

 

[M20FES]

Your slackening it off half a turn so not long at 200nm

yes, got it mate after i posted my last comment. thanks for your help

its all back together and working now