lcr drivers door sensor/switch - buzzer, lights not working

t32er

Guest
this is doing my head in and nearly cost me a jump start at trax if it wasnt for one of the guys (be it nearly 3 hours after parking) let me know i had left me lights on

the issue is my warning buzzer has stoped working, also the light on the door card wont work nor will it put the inside lights on when i open the drivers door, wehats going on?? iv checked fuses all seem and look ok unless i have missed one (Lee your tha master of this, shout numbers at me)
BUT now and again it will work...

another prob i seem to have developed is my speakers
one min they all work then a front speaker will stop working, then come back and then the other side goes, tweeters seem fine, dooing my :censored: head in to be honest...

HELP ME :cry:
 

t32er

Guest
cool beanzzzzz
i take it it will be door side and not the shut...
i might strip it down and take a look, can check the speakers at the same time, could be some water in there may be??
need to see whats up with my drivers seat to lol
iv put elec leathers in it, they have stopped moving backwards??? still go up down, tilt, forwards just wont go back...
 

GREY 225

Jim R
Oct 15, 2006
445
0
Yep common fault. It will be micro switch built into the door lock that tells ecu when door has been opened.
Not a 5 minute job to replace though.
 

t32er

Guest
a life saver again lee
do ya think rather than replacing the worn part i could put some sork of ne "seal" like thing over it? it might work... will see at the weekend, if the weather holds off that is
 
Adrian Flux insurance services - discount for forum members.