today i got the car up on the ramps and took the exhaust off the turbo to clean the crud out of it.
this seems to have worked,but i noticed a small amount of play in the turbine on the exhaust side.a tiny amount,but i could definitely move it.i didn't want to try and tighten it in case i broke it,but i am concerned that any play in something spinning at the rate it does is not good at all.
IF this is the beginning of the end of the turbo,is there a way of just bolting on another that will improve performance,without changing too much ,and therefore costing me a fortune.
this seems to have worked,but i noticed a small amount of play in the turbine on the exhaust side.a tiny amount,but i could definitely move it.i didn't want to try and tighten it in case i broke it,but i am concerned that any play in something spinning at the rate it does is not good at all.
IF this is the beginning of the end of the turbo,is there a way of just bolting on another that will improve performance,without changing too much ,and therefore costing me a fortune.

