Software settings

[Mekon]

I drive a Seat Leon Cupra 300 TSI 4Drive Estate. It enables me to set my individual preferences for steering response, suspension firmness, engine configuration etc. which I can then call up by tapping a single 'custom' button on the screen. However, every time at switch-on these settings revert to 'default' and I have to select 'custom' again. Very annoying! It would be far more sensible (and far less irritating) of at switch-on the setting would be unchanged from the previous switch-off. Any ideas how - if at all - this could be achieved?

Mekon

 

[H Rafiq]

I have a Leon Cupra 280. If I leave the car in Cupra, the next time I come to get in the car it’s still in Cupra.

 

[Maypack]

I have a Leon Cupra 280. If I leave the car in Cupra, the next time I come to get in the car it’s still in Cupra.

The car is in Cupra but the engine defaults to Comfort even though it says that you are in Cupra Mode. This is standard across all Leon Cupra’s.

You have to reselect Cupra mode to get “Full” Cupra mode again.


Sent from my iPhone using Tapatalk

 

[H Rafiq]

Possible with OBD? AC and heated seats are remembered form the previous drive.

 

[Mekon]

Sorry one and all! I'm new to this forum and hadn't realised that the topic of 'individual' set-ups not being retained after switch-off (and the annoyance of having to re-select 'individual' every time at switch-on) has already been thoroughly covered by earlier threads! I notice that at least one solution has been offered in impressive detail, but the actions required to implement it are way above my pay grade! So I'm planning to just calmly live with the annoyance!

Mekon