Somthing messed up with the alloy on the edge..... so Ive put them Back down to bare alloys , and leaving them till i replace them. Also refurbed the centre caps in black with Seat Badges
started masking , will be finished off soon , will be prepping after my holidays. so hopefully will have the car finished mid september then the modding will begin
Not so much the blending. Its about getting the same amount of paint on and in the same manner.
I'm not a painter but I was told this by a painter, and having seen a couple of Ovni cars painted, what he says is right enough.
Apparently its not as important to have bonnets/bumpers etc done at the same time, but because you can look down the side of a car and see the wing compared to the door, you should paint the full side in one go.
ok. ive spoke with my mate whos spraying it up. im not too fussed if its not perfect... the car is multi coloured at the moment haha all faded and has been keyed about 100 times all round. Nothing like returning a good car to how it should be
Begun prepping ..... will post pics after. Seat seem to have only done 1 paint layer and laquer, this will be replaced with 3 paint layers and laquer so should be a nice yellow when its done
Im thinking of using the right(from drivers perspective) hand side fog light hole to make a feed pipe to the SMIC .... will do the job and im waiting on my friend to come back from holiday and then we are starting the spraying 3 layers then laquer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.