Where can i order Pipewerx 3" DP & decat

[Craigus]

A pipewerx 3"dp and decat as im after one for my LCR.

 

[tgorman]

ring pipewerx

 

[CupraMVR]

awesome is a dealer give us a ring

 

[Craigus]

Ah kewl, what set up have you got again John?

 

[CupraMVR]

Im running a pipewerx 3" downpipe and decat milltek non rev mid section and back box.

got some good power from it last time on the rollers

 

[JamJay]

You're not Hybrid are you John? I can't remember what you've done to yours to get those figures, just hope i'll get there one day. Had a couple of issues with the car recently, well not really, but I think the MAF is dying so I'm thinking of treating her to some better breathing as a present afterwards

Is Milltek 2.5 or 2.75" by the way?

 

[Craigus]

John i have had a word with Awesome, they say they can only supply the DP, no mention of the DC pipe, and that i would be looking at about £600 just for the 3" DP supplied and fitted? sounds pricey just for the DP.

 

[lc_allan]

Sarah says in her message the decat and downpipe is £450 inc VAT.
I would assume that is both and seems about right.
I've also got the full system with a 200 cell cat and it's a quality bit of kit

 

[JamJay]

How much was the whole lot with the 200 cell allan?

 

[lc_allan]

£800 fitted but the price of metal has gone up considerably it seems. It won't be as cheap as that again.
Same as Blueflame has increased their systems from around £625-£640 to about £800 also.

 

[Craigus]

Ah rite cheers my bad, that aint a too shabby price then.

 

[JamJay]

Not fussed about the fitting, I have a ramp of my own for that. So I'm guessing that's circa £500 supplied then? I know a full TB System is about £800 supplied these days.

 

[lc_allan]

How much was the whole lot with the 200 cell allan?

Just 30 mins ago sailed through it's first MOT being on the car. Been on since last December.

 

[Craigus]

Thanks for the advice allan i have sent the guys at Pipewerx an e-mail.

 

[CupraMVR]

You're not Hybrid are you John? I can't remember what you've done to yours to get those figures, just hope i'll get there one day. Had a couple of issues with the car recently, well not really, but I think the MAF is dying so I'm thinking of treating her to some better breathing as a present afterwards

Is Milltek 2.5 or 2.75" by the way?

im not hybrid yet jamjay maybe on the cards soon. done a bit of work on mine to get good figures on standard turbo and clutch.

2.75 is milltek systems on the leons

 

[DPJ]

I have a 3" Pipewerx DP. Thoroughly recommended.

 

[Craigus]

Good stuff im waiting a reply from Iain at Pipewerx.

 

[CupraMVR]

Yea really good downpipe. fits nice aswell. i had mine heat wrapped just downpipe tho

 

[Craigus]

Whats the plus points of heat wrapping it John?

 

[CupraMVR]

exhaust wrap helps keep the heat within the exhaust system reducing under bonnet temperatures and helping maintain a cooler engine bay

+ it looks pretty