-
Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.
what did you and your mk3 leon do today
- Thread starter seatleon2012
- Start date
Changed my air filter for a Pipercross foam one
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Must do this to mine. What did you use to clear off the bits of sticky?#smooth
Sent from my iPhone using Tapatalk
Air gun / hair dryer caught a corner and just my finger to roll it in to a ball. Then a non abrasive polish (auto finesse)
Sent from my iPhone using Tapatalk
Might have to do that tomorrow and then clean it
I used WD40 came straight off just in case you don’t have a specialised cleaner!
Sent from my iPhone using Tapatalk
Which engine? How does this improve the performance?
Sent from my SM-G960F using Tapatalk
1.4 TSI 150 - not had a chance to drive it yet so can’t say sorry
Sent from my iPhone using Tapatalk
Does it make any difference to sound etc?1.4 TSI 150 - not had a chance to drive it yet so can’t say sorry
Sent from my iPhone using Tapatalk
Seems fairly easy to fit?
Sent from my SM-G960F using Tapatalk
I’ll report back about the sound but on fit it was fiddly but not too difficult once I’d googled it. You have to disconnect the Airbox and ‘pop’ it out it sits on some little ball sockets which hold it in place. To do that you need some large pliers (I used adjustable plumbing ones) to disconnect the air intake feed pipe and the air ‘out’ pipe into the engine (there’s another small pipe I didn’t bother to disconnect as the top of the Airbox stays in the engine bay). Then there are 4 clips around the outside which you need to pry open with a screwdriver. Once you’ve removed the bottom of the box there are two posi screws underneath which hold the filter in place.
Awkward but not too hard.
Sent from my iPhone using Tapatalk
Hooverd, dusted and quick clean. Mainly dust and the wheels needed doing. Oh and debadge
Hooverd, dusted and quick clean. Mainly dust and the wheels needed doing. Oh and debadge
How did you get on??
Sent from my iPhone using Tapatalk
Not too bad, hairdryer and floss to start with, tar remover worked well and then applied dodo juice. Thanks for the reminder
Unrepairable puncture yesterday. All I can say is that I'm so glad I bought a car with a spare wheel. Only 20 minutes to swap the wheel (most of that spent getting the caps off the lug nuts)
Couldn't imagine having to deal with that shitty gunk stuff or waiting for recovery.
Couldn't imagine having to deal with that shitty gunk stuff or waiting for recovery.
Where did you get it remapped bud? Got a GTD and very interested.
Finally bite the bullet and had my 184 tdi remapped. Goes like **** off a shovel wish I got it done sooner. I've lost the dyno print out but it's now 220bhp
Had the Seat styling kit fitted this week (rear bumper, spoiler and side skirts)
Kept original exhaust because, well £500, and actually like the original look.
FY15 plate.
Black always looks better in real life not sure these pics do it justice ! I am chuffed though, sits lower and has more aggresive look without being OTT.
Also had steering wheel swapped for newer fy18, feels nicer and more premium.
Should stop me buying a new car for a couple of years
Pic 1 - original
Definitely an improvement! Did you just ask your local dealer to fit all of these or did they ask if you wanted the styling pack at some point? My Cupra definitely needs side skirts or blades but not sure if I should wait and mention it to them when I go for a service
Sent from my iPhone using Tapatalk
I contacted the parts team at Lookers Manchester. They had some skirts in stock as previous parts manager bought loads, so they were keen to do a deal.
Maybe worth giving a call depending on where you are based!
They did a great job and i even got a bottle of champagne out of it lol
Sent from my SM-G960F using Tapatalk
Similar threads
